40K HEADQUARTERS
Board
a small 40k build ,,, headquarters for you to place where wanted
the green sphere is the measurement sphere ,,,,, it should save with the board,,, but if not aline the tool up on the tube sphere and pull out until in the right position,,,, a bit fiddley but do-able
there are three minis with this board,,,,one as a statue and the other clipped in to a seat the other is a statue on the front.the minis ,,,to replace them the one set in the controls removed the seat and place it then replaced the seat,,,,the large statue reduced its side to two sizes smaller then place just behind the cable on the floor then enlarge to 3×3
Moving the board will not included the sphere or the minis